Sliding glass door track fills with water re.
Sliding door track wet after rain.
Blocked weep holes cause water to pool around the base of a sliding door and possibly spill into the home.
After approximately 30 minutes wipe wet dirt and soap scum off with a new damp cloth.
If there are no weep holes or the track is installed incorrectly this might cause the issue.
If you notice moisture in your home when it rains there could be several causes according to a 1 on track the sliding door professionals.
My advice is to carefully remove the aluminum trim that s covering the wood trim that surrounds the sliding patio door.
It s usually a 1 8 or so gap at the ends of the track channel or there is no raised barrier at all as yours seems to have.
Open and close the door over the sandpaper several times to remove material from the door s bottom edge.
Small slots in the exterior section of track provide drainage when water comes in contact with the glass door.
These are commonly called weep holes.
Sliding doors are normally manufactured with weep holes in the track which allow water to drain out.
The openings often become clogged with dirt and debris.
Your operator the panel that slides track must have a method for the water to void from the track.
It is true that sliding door tracks car harbor water after a hard rain but several inches sounds like a lot.
If that is a track for a slider then yes it is normal for water to get in there as it is just like a sliding glass door water enters the track under the slider and flows to the fixed side.
The lower track of a window frame normally is supposed to have small holes at its lower edge toward the outside that allows water in the track to drain out.
After that repeat the process with the new amount of paste.
Then remove any wood trim around the door.
If the bottom edge of a door rubs the threshold or floor try taping a piece of sandpaper course side up to the floor so the sticking point will pass over it.
If the dirt layer is too thick you should use a metal scraper or knife to remove some of it.
Weep holes are supposed to be there to allow the water to drain out to the outdoors.
Wipe the track with a clean cloth and make sure the weep holes at the base of the door are open.
Use an old cloth and apply the paste to all the shower door tracks.