Replacing them is easy but first you have to get the door off the track.
Sliding door off the track.
In this photo you can see the large round screw head that is.
Slide the door over.
You will be able to tell the wheels are sufficiently.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
Slide the door as far as you can into the opening.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
Kung fu maintenance demonstrates how to replace some wheels that are not rolling right on a patio slider door that is coming out of it s track and not rollin.
Align each adjustment screw with.
Do this carefully you do not want to pop the back hanger off.
The door may come completely off when you go to lower it.
First locate the roller adjustment screws and use a screwdriver to turn the.
The wheels are plastic and they stick or break causing the door to jam.
Find sliding closet door tracks track kits at lowe s today.
Instead these wheels ride the track.
There should be an even and uniform separation all the way along the top and bottom.
The back roller and hanger will push the front one out to where you can reach it.
Pull the bottom of the door out towards you and set it down off of the track.
Pushing the wheels up will make it easier to.
While holding the door up pull it 4 8 in 10 20 cm towards you and then lower the door to the floor.
Slip a flat screwdriver underneath the wheels and push them upwards.
Once it reaches the floor check the bottom track to make sure that it s completely off.
Sliding closet doors fall off tracks first check the alignment of your closet doors.
Pull the door up from the bottom track until the wheels are out.
Place the door on a pair of sawhorses for easy access to the rollers on the bottom.
When you re done replacing the door is just as easy.
Stand back five feet or so and examine the gaps on the top and bottom.
When you open or close the door it doesn t actually slide.
Note that the rollers of the door shown here reside up inside a.
Reinstall your clean rollers.
When you have the front door hanger in the opening you are ready to put the pocket door on the track.
2 pull out the rollers and the weatherstripping gasket.
Remove the door from the track.